111 Pass
112 IAT Value is too low.
113 IAT Value is too high.
114 IAT Voltage out of range.
116 ECT Value is out of range
117 ECT Value is too low.
118 ECT Value is too high.
121 Throttle position sensor out of range
122 Value for Throttle position sensor too low
123 Value for Throttle position sensor too high
126 MAP Sensor out of calibration
129 Failed Goose test
157 MAF voltage too low
158 MAF voltage too high
159 MAF Voltage out of normal range
167 No Throttle Position Change in Goose test
172 System always lean
173 System always rich
176 System always lean
177 System always rich
211 PIP Erratic during Idle test
214 CMP Sensor Input failed
215 EDIS Coil A failed to fire
216 EDIS Coil B failed to fire
217 EDIS Coil C Failed to fire
226 Unknown EDIS Coil Failure
227 Knock Sensor Failure
232 EDIS CPU failure
327 EGR Voltage too low
328 EGR Valve position Low
332 EGR Valve not working
334 EGR Valve position too high
335 EGR voltage out of normal range
411 ISC Low Idle fail
412 ISC High Idle fail
452 Speedo Signal Fault
511 Internal EEC V Fault
512 Internal EEC Fault
513 Battery Voltage Too Low
521 PSP Failed
522 Transmission in wrong gear or A/C is on
523 AC Blower Fan Sensor fault
524 LPG Enabled LPG option is selected
538 Operator did not goose
578 Battery Voltage too low
628 Trans Mode Switch Fault
634 Gear Selector Sensor Faulty
636 Trans Oil Temp Fault
637 Trans Temp Link Stuck high
691 Trans Solenoid 1 Faulty
692 Trans Solenoid 2 Faulty
693 Trans Solenoid 3 Faulty
694 Trans Solenoid 4 Faulty
695 Trans Solenoid 5 Faulty
696 Trans Solenoid 6 Faulty
697 Trans Solenoid 7 Faulty
777 Drivers side Cooling Fan not operating
778 Passenger side Cooling Fan not operating
783 Serial Link output check fail
784 EGR Output check fail
785 CANP Output check fail
786 PIL Output check fail
787 Fuel Pump Output Check Fail
788 ACC Output check fail
789 RCO Output check fail
791 FC1 Output Check Fail Electro Drive fan 1 output is faulty
792 FC2 Output Check Fail Electro Drive fan 2 output is faulty
793 FC3 Output Check Fail Electro Drive fan 3 output is faulty
794 FC4 Output Check Fail Electro Drive fan 4 output is faulty
795 BBM Output Check Fail Broad Band Manifold output is faulty
837 Evaporator temperature voltage too low.
838 Evaporator temperature voltage too high
839 Evaporator temperature voltage out of normal range
844 Vehicle Immobilised EEC is not receiving the enable code from the BEM
845 Vehicle Immobilised – Plant Mode Immobilisation system is still in plant mode
998 ER Test Error In the ER test, one or more of the major sensors (IAT, ECT, MAP, TP) are faulty.
pop